Asus Z97-P (Bricked BIOS)

[minethebestcraft]

Hello,
A while back I had some problems with an Asus Z97-P after BIOS flashing and a Power Outtage.
So here is the question I have.
Is it possible to use a completly different MB with Dual BIOS remove the secondary BIOS Chip and flash the Z97-P BIOS onto the bricked chip. The other MB in Question is a 2nd Gen Intel Chipset with a i3-2300 on it.

 

[romirez]

Even if it is possible - not all bios chips are compatible.
Better just to use cheap USB programmer (around 20$).

 

[minethebestcraft]

Even if it is possible - not all bios chips are compatible.
Better just to use cheap USB programmer (around 20$).

Is there maybe one you could suggest to meine. Since there are so many types of BIOS chips and I dont want to by one that doesnt even have an fitting socket.

 

[romirez]

Dont know exact marking of your bios chip. Try to get the same.
Ebay got few propositions.
LINK

P.S. Dont forget about correct position of bios chip (see key)

 

[minethebestcraft]

Okay, after I worked on some other Boards to calm a bit. I found a speaker on my H61 and connected it to the Z97.
The result:
A short beep. If I recall correctly that means everythings fine and you are good to go. So the BIOS should be fine.
I am just getting no video, better say my Monitor gets a Signal, but it stays black.
I already cleared CMOS with the Jumpers and removed the battery while the PSU was off, but I am still getting nothing, but black.

 

[romirez]

Did you checked integrated video? (if your CPU have)

P.S. Dont use two videocables connected.

 

[minethebestcraft]

I tried using iGPU, nothing.
I tired using a Radeon HD4350 and a GTX460, nothing.
I tried all ports I got. HDMI, DVI and VGA. I even tried a 3D Blaster Banshee in the PCI Slot.

 

[romirez]

Still may be bios.