Athlon XP OC - meter reading

[Guest]

I am looking for information on what exactly the ohm readings across the L1 bridge should be after filling and painting.
From top to bottom of a single bridge- should be zero?
From Bottom to top of 2 different bridges should be ???
From painted bridge to painted bridge should be???

Any help would be appreciated.

 

[Lonemagi]

There should be no ohms, just as if you would connect the 2 leads of the meter together, and then check the bridges to the circle or triangle (ground), to make sure you have filled the laser locks right.

Once I thought, then I <A HREF="http://www.warroom.com" target="_new">learned</A>

 

[khha4113]

I used Ohmmeter to measure them, and they're about 0.2 OHMs (but that I soldered them by using copper wires).

Good or Bad have no meaning at all, depends on what your point of view is.