Build :-
Ryzen 3 1200 Processor
8GB DDR4 2400Mhz RAM
Zotac GeForce GTX 1050TI GPU
B350 Gaming plus Motherboard
So One fine day I was playing Skyrim on high settings(obviously the build had handled the game really well since 4 months on same settings so it wasn't the issue) and bluescreen of doom appears and shows restarting... few minutes later doesn't even load into bios.. I've tried restarting PC after 15mins of black screen.. and still no display from the PC..But all of the fans keep running thought it might take time so I've waited for 45mins still no display..
Knowing MSI has ez debug opened up my cpu and tried to see where the issue was.. when I restarted Processor Led lights up then DRAM Led lights up and go off without going into VGA and BIOS, So I thought the issue was my GPU so I got my GPU replaced and tried it on.. ez debug Leds act the same,so I switch to the other GPU slot as the board provides 2 slots..Still no result..
To put clearly how ez debug is acting(my pc is turning on)
1.When I turn on my pc(via the power button) all fans turn on.. (no display)
2.Ez Debug lights up processor led > DRAM led > both turn off.
3.Now PC is just there spinning fans doing nothing.
Sorry for my poor english(and over use of the full stops)
Please Help me(Thanking you in advance)
Ryzen 3 1200 Processor
8GB DDR4 2400Mhz RAM
Zotac GeForce GTX 1050TI GPU
B350 Gaming plus Motherboard
So One fine day I was playing Skyrim on high settings(obviously the build had handled the game really well since 4 months on same settings so it wasn't the issue) and bluescreen of doom appears and shows restarting... few minutes later doesn't even load into bios.. I've tried restarting PC after 15mins of black screen.. and still no display from the PC..But all of the fans keep running thought it might take time so I've waited for 45mins still no display..
Knowing MSI has ez debug opened up my cpu and tried to see where the issue was.. when I restarted Processor Led lights up then DRAM Led lights up and go off without going into VGA and BIOS, So I thought the issue was my GPU so I got my GPU replaced and tried it on.. ez debug Leds act the same,so I switch to the other GPU slot as the board provides 2 slots..Still no result..
To put clearly how ez debug is acting(my pc is turning on)
1.When I turn on my pc(via the power button) all fans turn on.. (no display)
2.Ez Debug lights up processor led > DRAM led > both turn off.
3.Now PC is just there spinning fans doing nothing.
Sorry for my poor english(and over use of the full stops)
Please Help me(Thanking you in advance)