I have a Barrow GJQM-01 System Leak Tester I am using to test my new loop now I pump it to 0.5 bar or just over and after about 30min all fine but after a few hours I notice the pressure has dropped a smidge. Now is this a problem or is it fine and will my loop hold water and not leak?
Now I did use a new gpu water block fill it with water then seal it up to check if it leaks and it does not but if I use the pressure tester it slowly leaks air.
I have also read some reviews that say the Barrow GJQM-01 System Leak Tester slowly leaks air. Can anyone confirm this please.
Now I did use a new gpu water block fill it with water then seal it up to check if it leaks and it does not but if I use the pressure tester it slowly leaks air.
I have also read some reviews that say the Barrow GJQM-01 System Leak Tester slowly leaks air. Can anyone confirm this please.
Last edited: