I've been searching all over Google for a solution, yet I'm having difficulty figuring out how my issue occurred.
Earlier today, I turned on my desktop to just check for some e-mails before going out for lunch with some family. I turned off my computer and then left for lunch. After 5 hours, I turn on the computer and it hangs at "Loading Operating System"
So I checked out my BIOS and as I suspected, my hard drives are no longer recognized.
My primary drive is a Kingston 64GB SSD. My other two drives are: 1TB Seagate and 2TB WD Green.
My Mobo is a Gigabyte GA-P55-USB3 Rev. 2 I'm running Win7 Ultimate 64-bit
I honestly don't get how something like this could occur, especially since I was able to use it earlier today.
So for troubleshooting:
I went into the CMOS and tried using the fail-safe default and nothing worked. I checked my PSU connections and sata connections in case anything was loose and they were fine. I disconnected my secondary drives and just left my SSD connected. My sata drives are set to IDE and I tried changing it to ACHS(?) and still no good.
I used different sata cables and even connected it to each different sata channel, but again nothing.
I'm not sure what else to do now. I'm not very knowledgeable about computer terminology as well...
I'd appreciate any help I can get. Thanks!
Earlier today, I turned on my desktop to just check for some e-mails before going out for lunch with some family. I turned off my computer and then left for lunch. After 5 hours, I turn on the computer and it hangs at "Loading Operating System"
So I checked out my BIOS and as I suspected, my hard drives are no longer recognized.
My primary drive is a Kingston 64GB SSD. My other two drives are: 1TB Seagate and 2TB WD Green.
My Mobo is a Gigabyte GA-P55-USB3 Rev. 2 I'm running Win7 Ultimate 64-bit
I honestly don't get how something like this could occur, especially since I was able to use it earlier today.
So for troubleshooting:
I went into the CMOS and tried using the fail-safe default and nothing worked. I checked my PSU connections and sata connections in case anything was loose and they were fine. I disconnected my secondary drives and just left my SSD connected. My sata drives are set to IDE and I tried changing it to ACHS(?) and still no good.
I used different sata cables and even connected it to each different sata channel, but again nothing.
I'm not sure what else to do now. I'm not very knowledgeable about computer terminology as well...
I'd appreciate any help I can get. Thanks!