This is my third try so ill be brief.
I have an Azza PT-5IT m board,according to the manual it can't support a cpu speed faster than 266mhz(at least there isn't a setting for it listed.)
My processor is a cyrixinstead, in another system it ran at 333mhz without overclocking(that board is dead).
I was asked in a previous posting for the bios i.d. These two lines are case correct, the first one is above the ram test,the second is in the bottom left of screen.
12/04/97 w83977TF for PT-5IT
11/18/97-i430TX-2A59IP89C-00
All the 0's are zeros
What i want is info on which jumpers effect the frequency multiplier, what configeration to use,and what jumper config I should use for the cpu in regard to the changes i want to effect(the cpu running a 333/366mhz).Well so much for this being brief, I'll sign of by saying HALLLLP!
later....
I have an Azza PT-5IT m board,according to the manual it can't support a cpu speed faster than 266mhz(at least there isn't a setting for it listed.)
My processor is a cyrixinstead, in another system it ran at 333mhz without overclocking(that board is dead).
I was asked in a previous posting for the bios i.d. These two lines are case correct, the first one is above the ram test,the second is in the bottom left of screen.
12/04/97 w83977TF for PT-5IT
11/18/97-i430TX-2A59IP89C-00
All the 0's are zeros
What i want is info on which jumpers effect the frequency multiplier, what configeration to use,and what jumper config I should use for the cpu in regard to the changes i want to effect(the cpu running a 333/366mhz).Well so much for this being brief, I'll sign of by saying HALLLLP!
later....
Facebook
Twitter
Instagram