Hi guys,
I recently replaced my 1600X cpu for a 5600X, system specs are as follows:
Motherboard - Asus Rog Strix X370-F Gaming (Running last BIOS version)
CPU - Ryzen 5 5600X
Memory - G.Skill Trident Z DDR4 3200 16GB 2x8GB CL14
In the past with my 1600X when i activated the DOCP mode, the system only did the training the first time, then it would boot up without doing any more training when i turned off my power strip (for example when i went to sleep or left my house).
After upgrading to 5600X, i reset the bios and enabled DOCP mode again, but every time i boot the computer after being without power (for example when I turn off the power strip) it performs the training, then it boots correctly.
It would be something like this > the fans start, turn off, start and turn off again and the third time the computer starts perfectly with its 3200MHz ram configuration.
Note > If I disable the DOCP mode and use default values in the BIOS the problem disappears.
And if I simply turn off the computer but don't unplug it, it doesn't happen.
Its normal?, any tip?
Thanks
I recently replaced my 1600X cpu for a 5600X, system specs are as follows:
Motherboard - Asus Rog Strix X370-F Gaming (Running last BIOS version)
CPU - Ryzen 5 5600X
Memory - G.Skill Trident Z DDR4 3200 16GB 2x8GB CL14
In the past with my 1600X when i activated the DOCP mode, the system only did the training the first time, then it would boot up without doing any more training when i turned off my power strip (for example when i went to sleep or left my house).
After upgrading to 5600X, i reset the bios and enabled DOCP mode again, but every time i boot the computer after being without power (for example when I turn off the power strip) it performs the training, then it boots correctly.
It would be something like this > the fans start, turn off, start and turn off again and the third time the computer starts perfectly with its 3200MHz ram configuration.
Note > If I disable the DOCP mode and use default values in the BIOS the problem disappears.
And if I simply turn off the computer but don't unplug it, it doesn't happen.
Its normal?, any tip?
Thanks