So I've been trying to install windows 10 to my broken pc, which constantly shows black screen even though we've installed windows 7 and 8 before on it. I was trying to fix it, at first it booted from the usb drive but then it can't find the hard drive, so I followed some command from this forum that was proven working but then after running them at restart my pc won't boot from the usb and instead shows me that error, anyone has an idea how to fix it? would greatly appreciate! Thanks in advance.
edit:
These are the commands I followed
Once in Windows setup, hit shift+F10 to bring up the command line.
>diskpart [enter]
>list disk [enter]
From the list above (assuming you have more than one HD installed, if not it'll be the only one), find the number corresponding to your HD.
>select drive [number] [enter]
>clean all [enter] * see note below
>create partition primary [enter]
>select partition 1 [enter]
>active [enter]
>format fs=ntfs [enter] ** see note
>assign [enter]
>exit [enter]
>exit [enter]
note:
-on "create partition primary" didn't work and told something about the storage is full or something (can't remember anymore)
- but on select partition 1, it worked so I thought I proceed on the process and after this everything after this command works, then on restart of my pc, it can't boot from the usb anymore which contains my windows 10 installer.
edit:
These are the commands I followed
Once in Windows setup, hit shift+F10 to bring up the command line.
>diskpart [enter]
>list disk [enter]
From the list above (assuming you have more than one HD installed, if not it'll be the only one), find the number corresponding to your HD.
>select drive [number] [enter]
>clean all [enter] * see note below
>create partition primary [enter]
>select partition 1 [enter]
>active [enter]
>format fs=ntfs [enter] ** see note
>assign [enter]
>exit [enter]
>exit [enter]
note:
-on "create partition primary" didn't work and told something about the storage is full or something (can't remember anymore)
- but on select partition 1, it worked so I thought I proceed on the process and after this everything after this command works, then on restart of my pc, it can't boot from the usb anymore which contains my windows 10 installer.