Bootmgr is missing

[Dragonic]

I was doing an overclock on my 8350 and everything was going OK but I decided to give up for now because I didn't had time to stress test now and all, then I went back to BIOS to cancel the overclock changes and I selected "Reset to defaults".

Since then, I get "Bootmgr is missing" when I turn the PC on.

Help please D:

EDIT:
At the BIOS only my CD-Drive and HDD were being displayed. I disconnected the HDD from the sata cable and left the PC only connected to the SSD, everything booted normally. Now connected the HDD back again and everything is fine again.
Wtf just happened.

 

[Ironsounds]

Hello... The Reset to "default settings" or you didn't the give the MB it enough time to Power down for a proper restart?

 

[Dragonic]

I selected "Reset to defaults" and gave it a proper restart time.

As I edited, I fixed the problem by forcing the PC to load the SSD.

I dunno why this happened but OK.

 

[Ironsounds]

Hello... the "default" setting may not be "your" Working BIO's settings... But the MB makers ones... And HD/SSD communication setting could have changed? always (save&exit) any changes to the MB BIO's.

 

[Dragonic]

Before trying to OC it I always ran it at the most defaults, apart from fan configuration.

 

[Ironsounds]

Hello... Is your BOOT drive in SATA0? that is a typical default.
You might want to confirm your Fan setting (other) didn't change too... B )

 

[Dragonic]

Dude. I already solved the issue (as stated in the edit). The SSD was not showing at the BIOS.