I am sorry if this was asked and answered as I have been searching online all day. It has been a long time since my last build and thought it was time for a new computer. I purchased the following parts and proceeded to put it together . After some , multiple tries, I thought I had it built. I turned it on fans spin, , light on front fans and memory sticks come on as well as the rgb on the board. I do not hear any beeps , not sure if I missed the case speaker or if it even has one as I did not recall seeing one or finding one when I went back in to look.
I do not have a separate graphics / video card installed but was just connecting to the on board video from the MB. I tried the HDMI as well as the DP port. I get no signal on the monitor when I turn it on , then monitor goes to sleep mode.
The set up is as follows.
ASUS AM4 TUF Gaming X570-Plus ATX
AMD Ryzen 5 3600 6-Core, 12-Thread Unlocked Desktop Processor
Thermaltake V250 Motherboard Sync ARGB ATX Mid-Tower
G.SKILL TridentZ RGB Series 32GB (2 x 16GB) DDR4 3200Mhz DIMM CAS
16 F4-3200C16D-32GTZR
ASUS ROG Strix ROG-STRIX-550G 550W ATX12V
WD Blue SN550 1TB NVMe Internal SSD - Gen3 x4 PCIe 8Gb/s, M.2 2280,
I connected the 20 pin into MB from the PSU and the 2-4 pin (in teh 8 pin socket) I also tried removing the 2-4 pin , and also tried installing just 4 pin into the pin set up as well all with no luck.
If you need or want pics I will take and upload .
Thanks
Brian
I do not have a separate graphics / video card installed but was just connecting to the on board video from the MB. I tried the HDMI as well as the DP port. I get no signal on the monitor when I turn it on , then monitor goes to sleep mode.
The set up is as follows.
ASUS AM4 TUF Gaming X570-Plus ATX
AMD Ryzen 5 3600 6-Core, 12-Thread Unlocked Desktop Processor
Thermaltake V250 Motherboard Sync ARGB ATX Mid-Tower
G.SKILL TridentZ RGB Series 32GB (2 x 16GB) DDR4 3200Mhz DIMM CAS
16 F4-3200C16D-32GTZR
ASUS ROG Strix ROG-STRIX-550G 550W ATX12V
WD Blue SN550 1TB NVMe Internal SSD - Gen3 x4 PCIe 8Gb/s, M.2 2280,
I connected the 20 pin into MB from the PSU and the 2-4 pin (in teh 8 pin socket) I also tried removing the 2-4 pin , and also tried installing just 4 pin into the pin set up as well all with no luck.
If you need or want pics I will take and upload .
Thanks
Brian