Can I overclock my CPU and Ram with these specs? And Maybe get to 4.5/4.7G for the CPU?

OCloudNine

Reputable
Jan 8, 2015
7
0
4,510
Specs: Cpu I7-4770K | Cooling H110 corsair extreme liquid cooler | Ram DDR3-G.SKILL RipjawsX 8GB | Video Card GTX 770 2GB | MB Gigabyte GA-G1.Sniper 5 | PSU 600W OCZ ModXStream Pro - 80 Plus
 
Solution
Fist of all don't go directly on
4.5-4.6 GHZ. Overclocking is a step by Step method. Don't overclock by any software because overclocking is not the thing that can be done by software. First set the XMP memory profile enabled to set your RAM correctly. Then Go in BIOS and find the CPU clock ratio, this is the multiplier setting. It starts at a multi of 35x 100(BCLK)(normal factory settings) to give you 3.5 Gigahertz. So up it .5 at a time and boot to os and test with P95 for stability and monitor your temps. (I think GA-G1 sniper motherboards comes with a bundled software named Easy tune that my GA-G1 sniper have, if yes then you can watch your temps by that software.) Do this for approximately 20 minutes. If it passes raise the multi...
Fist of all don't go directly on
4.5-4.6 GHZ. Overclocking is a step by Step method. Don't overclock by any software because overclocking is not the thing that can be done by software. First set the XMP memory profile enabled to set your RAM correctly. Then Go in BIOS and find the CPU clock ratio, this is the multiplier setting. It starts at a multi of 35x 100(BCLK)(normal factory settings) to give you 3.5 Gigahertz. So up it .5 at a time and boot to os and test with P95 for stability and monitor your temps. (I think GA-G1 sniper motherboards comes with a bundled software named Easy tune that my GA-G1 sniper have, if yes then you can watch your temps by that software.) Do this for approximately 20 minutes. If it passes raise the multi another .5 and try again. You'll get to a point where either P95 won't pass or your temp will gone so high. If the temps gone high you'll have to stop and work on cooling. If P95 fails then go to the Advanced voltage section in bios and add some volts to the CPU VCore . Stay in offset and just add a bit by tapping on the "+" key and test again.
 
Solution