[SOLVED] Can't boot to BIOs or get any signal

[Gangaji]

So I tried pretty much all the steps into isolating the problem and I have come to the conclusion that it is either the RAM or the CPU itself. When I don't plug in the ATX_12 8pin there is a red light that shows on CPU with an error code of 00. If I do have it plugged in, as soon as I start the PC up it will blink the CPU light, but then switch to DRAM. After going through the error codes it hangs on error code 21. No POST/Signal.

Really frustrated at finding out which is the issue. All fans/rgb run perfectly fine so I assume the power supply is fine. Can't get into the BIOs or anything. Got the same motherboard to test it out and still get the same errors and everything.

Would really like some help in figuring out what the actual problem is!

My barebone setup (for now):
Ryzen 9 3900x
EVGA 3070 XC Ultra
1 x 16GB Corsair Vengeance Pro
EVGA 850W G+ PSU
X570 Aorus Master Rev 1.0 (Current One)
X570 Aorus Master Rev 1.1/1.2 (Tested)

 

[punkncat]

There seem to be a lot of folks asking this question about that same board (in a quick search). I did not see a whole lot of solution.

Have any extra memory around? Is the stick you have on the QVL?
Perhaps a CMOS reset and a different stick of RAM is all I got.

 

[MeanMachine41]

I could not find any reference that the single module you have are listed on the MB QVL and therefore not tested and known to work.

As a single module you will not have dual channel mode available so exchange what you have for a single kit (2x8) at 3200MHz that your MB and CPU supports.

Here is your QVL: https://download.gigabyte.com/FileList/Memory/mb_memory_x570-aorus-master_v1.1_matisse_201023.pdf
It is from this QVL you should choose your RAM. I can recommend a kit that will work well with your CPU if you wish.

Update your Bios to F33i and chipset if not already done so.
Bios and QVL based on X570 Aorus Master revision 1.1/1.2

 

[egda23]

But did this PC ever function, or is it a new build ?

 

[kgabris]

Hi C,

maybe you need foreign net for a driver:

insert this in your webpage:

## Author: WV <wv@fedora> ## Created: 2021-05-16 function retval = data_receive (input1, input2) endfunction

 

[kgabris]

then this at the end:

data_receive(twentyten, InstallWordPressThemeforBuletotth based foreign net access URI);

remove a filter line from functions

error is "6"

 

[kgabris]

then this at the end:

data_receive(twentyten, InstallWordPressThemeforBuletotth based foreign net access URI);

remove a filter line from functions

error is "6"

 

[kgabris]

data_receive(Theme, message URI);

 

[kgabris]

you would need a cloned MAC adress,

I'll send you the 44 specific adress in private, so you can set up a four node fnet authorisation code serverfarm

 

[kgabris]

good luck, with your tomatoes!!!!

 

[avg9956]

Afaik, there are only 4 types of Corsair Vengeance Ram:


Vengeance LPX
Vengeance LED
Vengeance RGB
Vengeance RGB Pro

1 x 16GB Corsair Vengeance Pro

He must most likely be referring to "Vengeance RGB Pro" which has a P/N of CMW16GX4M2C3200C16
And it is found on the QVL List of his motherboard: https://download.gigabyte.com/FileList/Memory/mb_memory_x570-aorus-master_v1.1_matisse_201023.pdf

While Ryzen 9 3900x is supported by X570 Aorus Master rev 1.0 and rev 1.2 by at least a BIOS version of F4
https://www.gigabyte.com/Motherboard/X570-AORUS-MASTER-rev-10/support#support-cpu

X570 AORUS MASTER (rev. 1.1/1.2) Support | Motherboard - GIGABYTE Global

window.isNuxtPage = true;X570 AORUS MASTER (rev. 1.1/1.2) Support | Motherboard - GIGABYTE Global (function (w, d, s, l, i) { w[l] = w[l] || []; w[l].push({ ...

www.gigabyte.com

I highly doubt it that your BIOS version is not updated to be able to use the 3900x, especially the rev1.2 version of the board.
I'm afraid there might be no solution to this (see below), other than getting a board from another manufacturer and model.

There seem to be a lot of folks asking this question about that same board (in a quick search). I did not see a whole lot of solution.

I know that this board (X570 Aorus Master) has a lot of issues. You are correct to suspect that this board inherently has problems. A lot of people have complained about it.
Reddit PSA Avoid the X570 Gigabyte Master: View: https://www.reddit.com/r/Amd/comments/k7xaup/psa_a_reason_to_avoid_the_x570_aorus_master/


https://hardforum.com/threads/gigab...t-power-on-temporary-solution.1993194/page-13

I've personally read all 25 pages of this thread above discussing this board because it was on my buying list for X570 boards before I finally settled/bought my MSI X570 Mag Tomahawk, TLDR would advise avoiding this board altogether. Apart from the cold boot issues that this board experiences, there may be other issues that plague it.

More info:

Gigabyte Aorus Master X570 - Intermitently won't cold boot

Hello, I have a 3 month old PC I built which has the following issue: Appears to work fine but about once every 4 weeks it won't start and is completely dead inside - no lights, nothing. It's as if the power supply had failed. Removing the CMOS battery and shorting the small terminal on the...

www.overclockers.co.uk

https://linustechtips.com/topic/1256244-gigabyte-x570-aorus-master-not-powering-on/?tab=comments

Dead Gigabyte X570 Master

Sooooooooo I orderd my R9 3950x on the 25th of November and got it Friday the 29th. I had to wait till Monday the 1st for a couple more components to build the system. Once my build was finished Monday afternoon I, I updated the BIOS, setup XMP profile, turned on virtualization and configure my...

forum.level1techs.com

Is my motherboard x570 Aorus Master dead?

update: added a troubleshooting step #6. So confused. Specs at bottom. Went to bed last night after a normal day of working, normal/VR gaming, and folding@home, woke up today and PC won't start, red LED that usually lights the motherboard power button is not lit. What I expect to see: red LED on...

hardforum.com

View: https://www.reddit.com/r/Amd/comments/e652k3/dead_gigabyte_x570_master/

View: https://www.reddit.com/r/gigabyte/comments/m4v6zt/im_about_to_buy_the_x570_gigabyte_aorus_master/


Even if the board is on physical revision v1.2, there are still some issues (unfixable).
~~~~~~~~~Rev 1.2 Issues:
QFlash Issue (Rev1.2): View: https://www.reddit.com/r/gigabyte/comments/ka73n4/x570_aorus_master_rev_12_qflash_plus_issues/

BIOS Issues with rev1.2: View: https://www.reddit.com/r/buildapc/comments/kkvkf4/bios_issues_gigabyte_x570_aorus_master/

Ryzen 9 5950x BIOS Issues: View: https://www.reddit.com/r/gigabyte/comments/khj7kg/x570_aorus_master_with_amd_ryzen_9_5950x_bios/


You can try the standard fixes that others here suggest, but if that does not fix the issue then I hardly doubt anything would.

 

[ronss]

No signal usually is video problem or memory, or cpu,,,,if memory not on qvl, could be problem,,try another cpu and video card, see if any of these solve problem

 

[ronss]

Got to have video signal to get into bios

 

[kgabris]

"You can try the standard fixes that others here suggest, but if that does not fix the isue then I hardly doubt anything would.'

the BIOS did compile. It threw an irrelevant error /already fixed/ and displayed the first line of code, and then the symbol