CAS Latency not correct in Bios?

[sciamwow]

Hey guys,
Here's my build: http://pcpartpicker.com/p/bbmLYJ
As you can see, my ram is CAS Latency 7 and 1600mhz. When I went into the Bios, however, I had to change it manually from 1333mhz to 1600mhz. And after a little more digging, I realised that the CAS latency in the bios is listed as, well, I'm not sure honestly. It's all on Auto, but I see no 7s next to where the numbers are listed if that makes sense. How can I correct this?
Thanks

 

[Tradesman1]

Need to set it manually 😉

 

[Pinhedd]

Need to set it manually 😉

^this

The motherboard firmware will compute the timings based on the SDRAM manufacturer's JEDEC specifications, not what the DIMM manufacturer has specified.

 

[sciamwow]

Need to set it manually 😉

^this

The motherboard firmware will compute the timings based on the SDRAM manufacturer's JEDEC specifications, not what the DIMM manufacturer has specified.

But there are so many slots to fill in with numbers and I don't know what goes where...
Do you know of any tutorials?

 

[sciamwow]

Need to set it manually 😉

Read above post

 

[Tradesman1]

Simply start with the correct data rate (1600) and the 4 primary timings, along with the correct voltage and try

 

[sciamwow]

Simply start with the correct data rate (1600) and the 4 primary timings, along with the correct voltage and try

I'll see if I can add my bios pictures

Edit:

http://www.mediafire.com/view/dn51zaykeg6z3wn/150224154047.BMP

http://www.mediafire.com/view/vhhybxn1ka6sydq/150224154058.BMP

This is my ram:
http://www.newegg.com/Product/Product.aspx?Item=N82E16820231536&nm_mc=AFC-C8Junction&cm_mmc=AFC-C8Junction-_-na-_-na-_-na&cm_sp=&AID=10446076&PID=3938566&SID=

Thanks!

 

[Tradesman1]

OK

 

[sciamwow]

OK

Added links to BIOS pictures

Thanks for helping me Really I'm only a month into having my PC

 

[Tradesman1]

1st 4 - DAS Latency to 7, RAS# to CAS# delay to 8, RAS# PRE time to 8, RAS# Act Time to 24, then go to the end (DRAM Command Rate) and change it to 2T (might start DRAM voltage at 1.55

 

[sciamwow]

1st 4 - DAS Latency to 7, RAS# to CAS# delay to 8, RAS# PRE time to 8, RAS# Act Time to 24, then go to the end (DRAM Command Rate) and change it to 2T (might start DRAM voltage at 1.55

Thanks!! Is there some way to benchmark/stress test it to make sure it works?

Edit: Downloading PassMark now after a quick google search

 

[Tradesman1]

Sure, Prime95 is a favored stress test, Asus has their RealBench test, for just the DRAM could simply run Memtest86