Hi All
Im just getting into a bit of Cisco at home but having some trouble getting my home network to communicate with the lab. I imagine this is fairly standard setup but despite a few days of pouring over articles its time to ask for help!
Il explain the setup as it is at the moment
Run as Modem------------Router 192.168.0.1
VirginMedia----------->TP Link VPN Firewall------->Cisco 2600 RT--------->Cisco 3750 SW
So ive configured port 0/0 on the Cisco 2600 to pick up a DHCP from my LAN which it did.
Port 0/1 is configured as 10.0.0.1 255.0.0.0 with DHCP running and DNS set to 8.8.8.8
Ive set this on fa0/1: route 0.0.0.0 0.0.0.0. 192.168.0.1
If i run a ping from the 2600 via putty i can ping my 192.168.x.x network. If i then connect my laptop to the 3650 switch i get an IP address from the dhcp (10.0.0.2) but i cannot ping IP's on my 192.168 network.
Im sure im missing something obvious here, do i need to setup a static route on my TP Link router from 192.168.0.0 -> 10.0.0.0.?
Im just getting into a bit of Cisco at home but having some trouble getting my home network to communicate with the lab. I imagine this is fairly standard setup but despite a few days of pouring over articles its time to ask for help!
Il explain the setup as it is at the moment
Run as Modem------------Router 192.168.0.1
VirginMedia----------->TP Link VPN Firewall------->Cisco 2600 RT--------->Cisco 3750 SW
So ive configured port 0/0 on the Cisco 2600 to pick up a DHCP from my LAN which it did.
Port 0/1 is configured as 10.0.0.1 255.0.0.0 with DHCP running and DNS set to 8.8.8.8
Ive set this on fa0/1: route 0.0.0.0 0.0.0.0. 192.168.0.1
If i run a ping from the 2600 via putty i can ping my 192.168.x.x network. If i then connect my laptop to the 3650 switch i get an IP address from the dhcp (10.0.0.2) but i cannot ping IP's on my 192.168 network.
Im sure im missing something obvious here, do i need to setup a static route on my TP Link router from 192.168.0.0 -> 10.0.0.0.?