G
Guest
Guest
Archived from groups: alt.internet.wireless (More info?)
Hi all,
Tried to find the answer, but cannot find it.
I have several computers running BSD/Solaris/Irix (yup, a real
Indigo2) which I would like to connect to my wireless setup.
Is it possible to put them all behind one 3Com OfficeConnect Wireless
11g Access Point in Client Bridge Mode (connected via a HUB)?
I've tried two computers behind a DynaLink WL-024 Ethernet-to-Wireless
Bridge (11 Mb), but that didn't work, because neither could connect. I
suspected this happened because of the low speed, but since I read the
3Com manual I'm not sure anymore:
"Client Bridge Mode is a secondary mode of the access point. When in
Client Bridge Mode th eaccess point will act as a wireless client,
allowing one computer to access a wireless network"
Anyone?
Thanks in advance.
Kind regards,
Peter
Hi all,
Tried to find the answer, but cannot find it.
I have several computers running BSD/Solaris/Irix (yup, a real
Indigo2) which I would like to connect to my wireless setup.
Is it possible to put them all behind one 3Com OfficeConnect Wireless
11g Access Point in Client Bridge Mode (connected via a HUB)?
I've tried two computers behind a DynaLink WL-024 Ethernet-to-Wireless
Bridge (11 Mb), but that didn't work, because neither could connect. I
suspected this happened because of the low speed, but since I read the
3Com manual I'm not sure anymore:
"Client Bridge Mode is a secondary mode of the access point. When in
Client Bridge Mode th eaccess point will act as a wireless client,
allowing one computer to access a wireless network"
Anyone?
Thanks in advance.
Kind regards,
Peter