CM MasterCase Maker 5t

[Martines91]

Hi,

quick question, does anyone know what aio cooler radiator (prefably w/ 140mm fan support) does the mastercase maker 5t support for the top mounting? Because I bought the corsair h110i and I can't mount it on the top part. It's because that the case hase some sort of rails that are supposed to go to the notches on the radiator and the radiator's notch spacing is too short. So I will have to sell it and buy a new one, with good spacing.

Thanks

 

[TrAAst]

Can you mount it in the front?

 

[Martines91]

I've tried but unsuccessfully, I might try again, but then in what configuration? push / pull? in or out? I will have to look at what clearance I'll have

 

[TrAAst]

You have one of the most common AIOs on the market and it should fit both at the top and front of the case.
Push or pull doesn't matter as long as it's mounted as intake in the front and as an exhaust if mounted at the top.

 

[raisonjohn]

Hi,

quick question, does anyone know what aio cooler radiator (prefably w/ 140mm fan support) does the mastercase maker 5t support for the top mounting? Because I bought the corsair h110i and I can't mount it on the top part. It's because that the case hase some sort of rails that are supposed to go to the notches on the radiator and the radiator's notch spacing is too short. So I will have to sell it and buy a new one, with good spacing.

Thanks

The Corsair H110i is a 280mm-radiator AIO but with an actual radiator length of 322mm (http://www.corsair.com/en-us/hydro-series-h110i-280mm-extreme-performance-liquid-cpu-cooler). The MasterCase Maker 5t, though supports 280mm-sized radiators for the top or the front, specifically states in its specs (http://www.coolermaster.com/case/mid-tower/mastercase-maker-5t/) that it can only fit up to a maximum of 297mm radiator length for the top (which means, you cannot fit it there) - but no limit was stated in the specs if the rad is mounted in the front. So, I would try the rad at the front first before considering buying another one.

 

[Martines91]

well that sucks big time, thanks for the answer though, guess I'll have to make a case modification, either changing the screws for longer ones or I'll have to file off the rails