so after i and my friend installed new cpu(we had to take out motherboard and all things)
when we booted pc
i got CMOS FAIL but pc still booted in,and my pc was lagging,and my pc also couldnt recognize my graphic card,i fixed that problem by trying to update and repair drivers.but
but my pc is still lagging and i still get cmos fail message everytime i boot my pc
Here's Message:
AMERICAN MEGATRENDS
Press <DEL> to ender setup.
Press <F9> to BBS POPUP
Press <F12> to BIOS POST Flash
Processor Type:AMD Ryzen 5 3600 6-Core Processor
Processor Speed: 3600 MHz
Total Memory:8192MB (DDR 4 2667)
USB Devices total: 2 KBDs, 1 MICE, 0 MASS, 0 HUBs
Detected ATA/ATAPI Devices...
SATA3: SPCC Solid State Disk, S.M.A.R.T Supported
SATA 4: WDS WD10PURZ-85U8XYO, S.M.A.R.T Supported
CMOS fail, Press <DEL> to enter setup.
What should i do ? i use A320MH ver 6.6 motherboard
when we booted pc
i got CMOS FAIL but pc still booted in,and my pc was lagging,and my pc also couldnt recognize my graphic card,i fixed that problem by trying to update and repair drivers.but
but my pc is still lagging and i still get cmos fail message everytime i boot my pc
Here's Message:
AMERICAN MEGATRENDS
Press <DEL> to ender setup.
Press <F9> to BBS POPUP
Press <F12> to BIOS POST Flash
Processor Type:AMD Ryzen 5 3600 6-Core Processor
Processor Speed: 3600 MHz
Total Memory:8192MB (DDR 4 2667)
USB Devices total: 2 KBDs, 1 MICE, 0 MASS, 0 HUBs
Detected ATA/ATAPI Devices...
SATA3: SPCC Solid State Disk, S.M.A.R.T Supported
SATA 4: WDS WD10PURZ-85U8XYO, S.M.A.R.T Supported
CMOS fail, Press <DEL> to enter setup.
What should i do ? i use A320MH ver 6.6 motherboard