Compressed Air Damage to PSU?

[locate.network]

First time cleaning after 4-5 months of owning pre-built (about 3k in parts) The only initial bug of mine was the PSU was loud and so replaced it for a quieter one. After months of good use I decide to clean it and I think too much compressed air turned to liquid inside the PSU (Or because spraying into it externally without opening it) but it got significantly louder right after until present.. I can feel the vibrations through the floor so much more and just unsure what to do...

It sounds crazy but I'm likely to buy another power supply just to have it quieter again but even with that decision this seemed so easy to make happen that I fear it could easily happen again. Do you have any advice, instructions on my current set up or new PSU to buy?

Thanks a million for taking a moment

 

[gareththegiant]

are the screws holding it in place tight as vibrations may be from it being loose

 

[cwli1_]

I doubt compressed air would harm it but it might have dislodged something. Unscrew it and see.

 

[locate.network]

are the screws holding it in place tight as vibrations may be from it being loose

Thanks for the reply,

Everything physically seems in place... All I can think is the air shot directly onto a coils area for too long. DIOS settings are still the same also. I don't think there's a solution I can find online for this, especially it being so minor but thank you guys for the bit of time you gave