I built this computer in 2017, and up until very recently, I've had no problems with it. I will leave as detailed a list of the components as i can at the bottom.
I was playing the new call of duty when I saw a flash behind my computer near the wall outlet. Just after this happened, the power went out for a few seconds and then came back on, but my computer would not power on anymore. There was no burnt or fried component smell present. The only indication of power being on when the psu switch is in the on position is the amber light on the ethernet port of the motherboard. It doesn't blink; it just comes on with the psu switch and stays on until the psu is turned off. Additionally my internet/ cable modem's ethernet port( a separate device plugged into the same surge protector) was no longer functional and had to be replaced by my provider's technician. The modem powered on fine and was recieving service from my isp, but the ethernet port no longer sent or received data.
I have taken components out and inspected them, unplugged and reconnected major parts like the gpu, and the computer still does not respond to being powered on. I believe it may be the power supply, but i'll have to wait to purchase a new one. The issue with my modem has me concerned though because whatever happened to it may have also happened to my pc.
My question is: how do i properly troubleshoot the issue? I haven't tested the psu using the paperclip method because i haven't found any clear enough instructions for safely doing so. I'd be willing to give that a go if someone can explain how it's done properly. Also, before my computer died, I'm now realizing that it was giving off a lot of heat... so much so that it was heating the room.
Components of my build are as follows:
Cooler master HAF X full tower case
Intel i7 6700k
Windows 10 64-bit
Z170 mx gaming 5 motherboard
- 850 watt psu 80 plus bronze
M.2 evo 1tb ssd
4x 8gb of ddr4 ram
Aorus 1080 ti gpu
Evo cooler master 212 cpu cooling
1x 3tb mechanical hard drive
2x 1tb mechanical hard drives
And 1x 500gb solid state boot drive for linux
Im not near the system while i write this, so some details like the brand and model of the psu will need to be acquired later. I believe the cpu and gpu were both overclocked, but only slightly and done so using software utilities that came with the hardware like the bios options for my motherboard.
Thank you for taking the time to read all of this.
I was playing the new call of duty when I saw a flash behind my computer near the wall outlet. Just after this happened, the power went out for a few seconds and then came back on, but my computer would not power on anymore. There was no burnt or fried component smell present. The only indication of power being on when the psu switch is in the on position is the amber light on the ethernet port of the motherboard. It doesn't blink; it just comes on with the psu switch and stays on until the psu is turned off. Additionally my internet/ cable modem's ethernet port( a separate device plugged into the same surge protector) was no longer functional and had to be replaced by my provider's technician. The modem powered on fine and was recieving service from my isp, but the ethernet port no longer sent or received data.
I have taken components out and inspected them, unplugged and reconnected major parts like the gpu, and the computer still does not respond to being powered on. I believe it may be the power supply, but i'll have to wait to purchase a new one. The issue with my modem has me concerned though because whatever happened to it may have also happened to my pc.
My question is: how do i properly troubleshoot the issue? I haven't tested the psu using the paperclip method because i haven't found any clear enough instructions for safely doing so. I'd be willing to give that a go if someone can explain how it's done properly. Also, before my computer died, I'm now realizing that it was giving off a lot of heat... so much so that it was heating the room.
Components of my build are as follows:
Cooler master HAF X full tower case
Intel i7 6700k
Windows 10 64-bit
Z170 mx gaming 5 motherboard
- 850 watt psu 80 plus bronze
M.2 evo 1tb ssd
4x 8gb of ddr4 ram
Aorus 1080 ti gpu
Evo cooler master 212 cpu cooling
1x 3tb mechanical hard drive
2x 1tb mechanical hard drives
And 1x 500gb solid state boot drive for linux
Im not near the system while i write this, so some details like the brand and model of the psu will need to be acquired later. I believe the cpu and gpu were both overclocked, but only slightly and done so using software utilities that came with the hardware like the bios options for my motherboard.
Thank you for taking the time to read all of this.
Last edited: