I just shutdown computer and now it won't boot up..
It'll run past initial post I.E. checks ram.. IDE drives ETC.. when it goes to second screen it stops at
DDR2 bank(s) 0 1.. with a blinking cursor under 1.(this changes when I put the memory in different slots)
I only have 2 gigs of ram.. I've taken them out and tried each of them in all different slots.. No luck..
Reset motherboard to fail safe defaults..
Cleared Cmos..
Same message..
I had the computer overclocked.. but it was running fine.. I shut it down today (manually) and now it won't come back..
I figure this is a ram problem.. The only thing that throws me is that it checks out ok (with the right amount) in the first post screen..
Any input would be appreciated.. Thanks.
It'll run past initial post I.E. checks ram.. IDE drives ETC.. when it goes to second screen it stops at
DDR2 bank(s) 0 1.. with a blinking cursor under 1.(this changes when I put the memory in different slots)
I only have 2 gigs of ram.. I've taken them out and tried each of them in all different slots.. No luck..
Reset motherboard to fail safe defaults..
Cleared Cmos..
Same message..
I had the computer overclocked.. but it was running fine.. I shut it down today (manually) and now it won't come back..
I figure this is a ram problem.. The only thing that throws me is that it checks out ok (with the right amount) in the first post screen..
Any input would be appreciated.. Thanks.