Configure jumpers in IDE Disk to use two disc on the same pata cable

[hardwaredrive]

Hello folks,

I have this disks:

1-https://snag.gy/XIQKTP.jpg
2-https://snag.gy/UaXRiz.jpg

I need use this disk which on of them a master and another as slave through pata cable. I don't know how I should configure the jumpers to I can use this two disk's in same cable. Because on this disk: https://snag.gy/UaXRiz.jpg I don't know wicht I should choose, if I should choose the option "16 Heads" or "32GB Clips".

Thanks to your help,
Best Regards

 

[ElectrO_90]

You set the jumpers as Master and Slave, whichever one you want to do first.
It really doesn't matter up to the point that if it doesn't work, you just change the jumper to another one.
It won't "break" by putting the wrong jumper, it just won't work until you find the correct one.

Plug one in as Master and see if it works
remove, plug the other as Slave, see if it works
then if they both do, put them both on the cable.

 

[karenjoly]

Pick the fastest and set it to master and the other to run as a slave. The master drive is the first drive at the end of the cable, the slave should connect in the middle. Use the 16 heads jumpers on the Hitachi. Here is some reading material

https://computer.howstuffworks.com/ide4.htm

 

[hardwaredrive]

This post it is resolved. Thanks to your great help!