Connecting N-Alvorix-RS880-uATX reset switch in new Thermal Take V3 chassis

[topend77]

The new case has a 3 pin connector for the reset switch but the power switch, power LED, and hard drive light connectors are all two pin.

The motherboard has a series of nine pins on the header and the diagram in the link below shows the reset pins as two next to each other but the connector has the two outside pins that are wired (so the middle one is dead).

https://goo.gl/images/GPFyt6

Here's the connector

https://www.dropbox.com/s/ua78jlrizkoglba/20171214_155107.png?dl=0

I'm wondering is it wired correctly or is the diagram correct? And will it cause a problem if I try to hook it up and try it?

Thanks,
Tim

 

[GhislainG]

Move a wire to the middle slot and strip the empty connector if need be.

 

[topend77]

Are you talking like stripping the wire and stick it in the middle section? When you say strip the connector...I was trying to find a way to pull that out and put it in the middle spot but it looks like as in there for good

 

[topend77]

Ha,I got it out with the pin. Thanks!

 

[GhislainG]

As you found out, they are easy to remove.