Hello!
I'm confused where to put this question but probably here ... so here it is...
I bought fan controller knob STW 6041 off Ali and it has molex power supply connector with 4 wires (none of them are coloured) but it has markings 1-2-3-4 on a header.
My PSU molex connector is : Red-black-black-Yellow(all of them x2)
and the way header placed(bottom/top) i had to connect Fan controller knob to PSU molex like this : 1 to Red wire which confuse me coz 1 should be ground...
I mean... all is functioning and STW 6041 doing its job of controlling fans speed etc(even did aida64 30m stress test)
Would it even work if i actually connected red wire to ground(black)?
Hope once again to get professional help from you tom's hardware guys, u the best!
I'm confused where to put this question but probably here ... so here it is...
I bought fan controller knob STW 6041 off Ali and it has molex power supply connector with 4 wires (none of them are coloured) but it has markings 1-2-3-4 on a header.
My PSU molex connector is : Red-black-black-Yellow(all of them x2)
and the way header placed(bottom/top) i had to connect Fan controller knob to PSU molex like this : 1 to Red wire which confuse me coz 1 should be ground...
I mean... all is functioning and STW 6041 doing its job of controlling fans speed etc(even did aida64 30m stress test)
Would it even work if i actually connected red wire to ground(black)?
Hope once again to get professional help from you tom's hardware guys, u the best!
Last edited: