[SOLVED] [Cooler Master MasterBox Pro 5 RGB] What are these cables?

[anhnt]

Hi guys,

I've finished assembling almost everything except for these two cables which I'm not sure what they are and where to connect them to my motherboard.

https://drive.google.com/file/d/1t8Uc_gVxqPws7m9b3zMm4oriF6nOwb8B/view?usp=sharing
-> From what I found on the internet, this one looks like an RGB cable, so I should connect it into JRGB on my motherboard?

https://drive.google.com/file/d/10Sna7o_RLUPUUbcQoe_k4SHfy1F_tBxA/view?usp=sharing
-> I wasn't able to find any information about this one so I have no idea what this one could be.

Btw, my motherboard is MSI MPG Z390 GAMING PRO CARBON ATX.
https://www.msi.com/Motherboard/MPG-Z390-GAMING-PRO-CARBON-AC/Specification

On another note, I connected the fan at the back of the case to Sys_Fan and was wondering if it's correct.

Thanks everyone.

 

[Barty1884]

The first images is an RGB connector - and would connect to RGB headers on the board for the integrated lighting, I suspect. You'd have to consult your MB manual for where they are, specifically.

The second, it's hard to tell... It kind of looks like Molex? Absolutely no idea what that would be for.

As for the rear fan, yes - any Sys_Fan (or Chassis_fan, depending on board labelling) is fine. Anything other than CPU_Fan, CPU_Opt of Pump_Fan.

 

[anhnt]

The first images is an RGB connector - and would connect to RGB headers on the board for the integrated lighting, I suspect. You'd have to consult your MB manual for where they are, specifically.

The second, it's hard to tell... It kind of looks like Molex? Absolutely no idea what that would be for.

As for the rear fan, yes - any Sys_Fan (or Chassis_fan, depending on board labelling) is fine. Anything other than CPU_Fan, CPU_Opt of Pump_Fan.

Thank you very much 😀