Hi Overclockers,
I have finally overclocked my Core i5-750 (10years late)
I was wondering if someone could give me some advice to hone my settings in a bit?
CPU: Core I5 750
CPU Cooler: HYPER 212X
Motherboard: GA P55 UD4
Ram: KHX1600C9D3 4GB & KHX1600C9D3K2 8GB
GPU: GTX 750
Power Supply: TX650
Currently I have it sitting at 3.6Ghz with a minor voltage increase.
The temps are sitting around 40'C idle running chrome with 10tabs.
I have seen some over clockers have got there chips up to 4GHz I'm wondering if that's feasible with the silicon I have?
Currently can't get past 3.6Ghz but I am new to OC'ing so it could be my settings or bad silicon...
Can somebody look at my BIOS settings and give me some feedback on what I should tweak with my current setup?
BIOS Settings:
Also you may have noticed that the two ram chips are slightly different, they support up to 1600, currently on running them at 1440 with 8 SPD Multiplier, and the DRAM Voltage set to 1.6.
Should I increase these? They also support CL 9 I have them set to 8 at the moment should I also change this?
Any other tips and tricks for my setup would be much appreciated!
Thanks!
I have finally overclocked my Core i5-750 (10years late)
I was wondering if someone could give me some advice to hone my settings in a bit?
CPU: Core I5 750
CPU Cooler: HYPER 212X
Motherboard: GA P55 UD4
Ram: KHX1600C9D3 4GB & KHX1600C9D3K2 8GB
GPU: GTX 750
Power Supply: TX650
Currently I have it sitting at 3.6Ghz with a minor voltage increase.
The temps are sitting around 40'C idle running chrome with 10tabs.
I have seen some over clockers have got there chips up to 4GHz I'm wondering if that's feasible with the silicon I have?
Currently can't get past 3.6Ghz but I am new to OC'ing so it could be my settings or bad silicon...
Can somebody look at my BIOS settings and give me some feedback on what I should tweak with my current setup?
BIOS Settings:
Also you may have noticed that the two ram chips are slightly different, they support up to 1600, currently on running them at 1440 with 8 SPD Multiplier, and the DRAM Voltage set to 1.6.
Should I increase these? They also support CL 9 I have them set to 8 at the moment should I also change this?
Any other tips and tricks for my setup would be much appreciated!
Thanks!