CPU cooler for AMD FX 8320.

[AniAM]

Need a heat sink for the processor. Which one could be suggested? HELP http://www.flipkart.com/deepcool-gammaxx-300-cooler/p/itmdh22yfu6nm6mc?pid=COLDH22W6ZUWBC5D&icmpid=reco_pp_same_cooler_8&ppid=COLD5XZPV75JZAEZ OR http://www.flipkart.com/antec-a40-cooler/p/itmdtpehfyudjvbg?pid=COLDTPEGZC9CFXGH&icmpid=reco_bp_historyFooter_cooler_3 OR http://www.flipkart.com/cooler-master-hyper-tx3-evo/p/itmd5xzprhxvefrj?pid=COLD5XZPV75JZAEZ OR
Temps- 42C to 47C when Browsing,movies,songs
62c to 66C while gaming(MW3/MW2)

 

[Dunlop0078]

I would use a cooler master hyper 212 its cheap and gets the job done if u want to do some extreme overclocking get a water cooler like the corsair h100i or the NZXT Kracken. Also noctua make good quality air coolers but there a bit pricey for air coolers.

 

[Dunlop0078]

Out of the 3 u picked i would go with the cooler master.

 

[bryonhowley]

Agree if I had to pick one of just those three I would go with the Cooler Master.

 

[AniAM]

Thank you people.

 

[AniAM]

I would use a cooler master hyper 212 its cheap and gets the job done if u want to do some extreme overclocking get a water cooler like the corsair h100i or the NZXT Kracken. Also noctua make good quality air coolers but there a bit pricey for air coolers.

Do I have to putting out the Mo.Bo to install that?

 

[DHFF]

If your case has a cut out behind the CPU then you can do it with the MoBo installed. If there is no way to access the back of the motherboard then you will need to remove it as the 212 requires a backplate installed.

 

[AniAM]

Yep it has the cutout. Using Antec V1. Hope you check that after!

 

[Outlander_04]

Of those three choices use the Deepcool gamma

Its the only one with a 120 mm fan . The others are small sinks with small fans

 

[DHFF]

If your case has enough room for a 120mm cooler then I would go with the Cooler master Hyper 212 EVO. its a fantastic cooler and comes with clips so you can easily add another fan for push pull. What I dont like about the Deepcool Gama are the heat pipes, if you look at the base you will see there is a gap between each pipe. For the best cooling you want all your heat pipes touching at the base. 120mm coolers are big though so make sure you have about 7" of clearance from your motherboard to the side panel.