Cpu doesn't boot

[reticula]

I bought a new Mainboard Z390 Aourus Elite. The Coil next to the ATX 12V 2x4 Connector broke (idk how I touched it and boom)so I soldered it back to his place . Now my PC isn't booting the Cpu (LeDs on Mainboard). I dont think it got a short because I double checked it. Maybe I burned the isolation in the Coil. But my Cpu should work (i5 6600k). I cleaned it with iso. Iam not quite sure if I connected the board right. There's is 2x2 and 2x4 pin ATX connector. I plugged my 2x 2x2 in the 2x2 and in 1 half of the 2x4

 

[Supahos]

Your cpu isn't usable on that motheboard. It'll only work on a z170 or z270 motherboard.

For further proof
https://www.gigabyte.com/Ajax/SupportFunction/Getcpulist?Type=Product&Value=6641

 

[reticula]

I bought a i9 9900k too but Iam a bit scared to test it. PC restarts after 1sec and than boots with dram and vga led. Does the Motherboard work fine ?Expect the (wrong) Cpu

 

[Supahos]

Absolutely no way to know. It's not ever going to work with your 6600k.