[SOLVED] CPU EZ Debug Light Flashing

[Venturus]

I just finished building my first pc but nothing works.
These are my pc specs:
Motherboard: MSI Bazooka B550m
Ram: OLOy 16gb Ram 8x2 3600mhz
CPU: Ryzen 5 3600
PSU: Enermax 850 watts gold-rated
HDD: Seagate 2TB
SSD: 512gb Patriot Viper
GPU: GT 710 (Going to upgrade when decent graphics card get back in stock)

My motherboard has a feature called EZ Debug Light and it shows my CPU has an issue. I'm not sure what the issue is and I've already tried reseating the CPU and reconnecting the CPU power cable.

 

[Bob.B]

I just finished building my first pc but nothing works.
These are my pc specs:
Motherboard: MSI Bazooka B550m
Ram: OLOy 16gb Ram 8x2 3600mhz
CPU: Ryzen 5 3600
PSU: Enermax 850 watts gold-rated
HDD: Seagate 2TB
SSD: 512gb Patriot Viper
GPU: GT 710 (Going to upgrade when decent graphics card get back in stock)

My motherboard has a feature called EZ Debug Light and it shows my CPU has an issue. I'm not sure what the issue is and I've already tried reseating the CPU and reconnecting the CPU power cable.

Make it smaller.
Unplug all disk.
Remove the gpu.
One stick of ram in the proper slot.
Test.

 

[drea.drechsler]

basically...bench test the system:

How To - Bench it - Troubleshooting

When All Else Fails - Bench It Let's start by looking at the mobo, is it installed in the case? If so make sure all mounting holes that can be used are used (normally six to nine) and have a standoff and screw used, no screwing directly to the case, need a standoff in each, otherwise mobo can...

forums.tomshardware.com

Also, reset CMOS. Check your manual.

 

[Venturus]

Make it smaller.
Unplug all disk.
Remove the gpu.
One stick of ram in the proper slot.
Test.

I tried doing this and nothing changed. The LEDS and the fans are working but nothing else is turning on.

 

[Venturus]

basically...bench test the system:

How To - Bench it - Troubleshooting

When All Else Fails - Bench It Let's start by looking at the mobo, is it installed in the case? If so make sure all mounting holes that can be used are used (normally six to nine) and have a standoff and screw used, no screwing directly to the case, need a standoff in each, otherwise mobo can...

forums.tomshardware.com

Also, reset CMOS. Check your manual.

I already tried resetting the CMOS using the CMOS battery and the CMOS jumper. I'm pretty sure a part is broken but I'm not sure what part it is.

 

[Bob.B]

I tried doing this and nothing changed. The LEDS and the fans are working but nothing else is turning on.

Next step.
On a piece of cardboard.
Mobo.
Cpu/hsf.
One stick of ram.
Psu.
If it still fails your down to 4 parts.