[SOLVED] ddr3 ram memtest errors on defaults settings

Jan 20, 2019
2
0
10
Hi everyone.I have the ram kit
CML32GX3M4A1600C10
Corsair Vengeance LP 8*4 ddr3
10-10-10-27
1.5V
1600MHz

There are a some errors by default settings and timings during i run memtest and windows diagnostic tool. After pc shutdown - everything works fine. That's a point. Would i increase or lower memory voltages despite of the defaults 1.5v? What's the value for high and low voltages i can set up for the that memory?Thanks in advance. Sorry for my english.

i sought out some information about voltages.
Some people told 1.65v, 1.61v, and even 1.4v helped them fix that problem.
 
Solution
The voltage is correct.
The errors detected by memtest indicate you have some bad memory locations. You can test each stick and each slot by starting off with one stick and if that stick tests good move it to the next slot. It's time consuming but you can determine if it is the modules or a slot.

If you are saying your PC works fine but not during the memtest it means that when you are using your PC the system hasn't needed to address the location in RAM.

Grugbug

Distinguished
Jan 22, 2016
508
0
19,160
The voltage is correct.
The errors detected by memtest indicate you have some bad memory locations. You can test each stick and each slot by starting off with one stick and if that stick tests good move it to the next slot. It's time consuming but you can determine if it is the modules or a slot.

If you are saying your PC works fine but not during the memtest it means that when you are using your PC the system hasn't needed to address the location in RAM.
 
Solution
Jan 20, 2019
2
0
10
Thanks for response. I use thats diagnostic tools again after pc booted up and there is no errors. Run an aida test, prime95 - no any other bugs and bsod

i having cold bsod every morning after long pc shutdown or if time after shutdown over 3 hours. Few days ago i cranked up memory voltage to 1.6v and start my pc after 6 hours. No error in memtest and windows tool! But after 9.5 hours of idle the utilities has been detected random errors. Ridiculous stuff. But maybe i'm on right way.