DDR4 RAM Won't Fit

[ChickenWang]

I've been having a lot of troubles with my RAM. No matter what I do it won't click in. Whenever I try to run my newly built PC it beeps indicating bad RAM. Sometimes it doesn't beep however nothing appears on the monitor.

RAM: http://

MOBO: http://

 

[Woohoopy]

Hey there, try this:

1). Try cleaning out the DRAM slots on your motherboard, and make sure there's no dust inside.

2). Make sure the "ears" on the side of the DRAM slots are properly "unhinged", by pushing them outwards lightly.

3). Place the RAM stick on the slot, and press down -quite hard- on both sides of the RAM stick using your thumbs. Attempt to make the pressure even on both sides.

4). If the plastic sides of the DRAM slot completely cover the golden teeth on the RAM, your sticks are properly installed.

Cheers mate, hope this helps.

 

[azaran]

Hey there, try this:

1). Try cleaning out the DRAM slots on your motherboard, and make sure there's no dust inside.

2). Make sure the "ears" on the side of the DRAM slots are properly "unhinged", by pushing them outwards lightly.

3). Place the RAM stick on the slot, and press down -quite hard- on both sides of the RAM stick using your thumbs. Attempt to make the pressure even on both sides.

4). If the plastic sides of the DRAM slot completely cover the golden teeth on the RAM, your sticks are properly installed.

Cheers mate, hope this helps.

Step 2.5). Make sure the notches in the DRAM slots of the motherboard match up with the notches in the RAM stick before fully pushing the RAM in to the DRAM slot. The sticks are keyed to only go in one way.

 

[ChickenWang]

Thank you both however that doesn't seem to work. It still refuses to go on and the going teeth are still revealed