Did I kill my 290? Graphics card acting up after g10 installation.

[Kespaa]

Hi guys,

I've got a r9 290 xfire setup that I have been running with for about a month. I've just installed two g10s with h55s on them hoping to decrease temps and noise.

I had planned on creating a thread on pre/post benchmarks, however it seems one of my cards is not firing up. This is what it looks like in GPUshark http://i.imgur.com/HJ2knUR.png . GPU3 is caped at 300MHz and doesn't seem to be used at all. My heaven benchmark score is well below what it should be as well so it isn't a software fault.

Any ideas on where I should go from here? I'm really hoping I didn't kill my card.

 

[unknownofprob]

your card is working, though doesn't appear to even be in crossfire.

Try each card individually just to check both cards are running smooth, and give each card a GPU test strain also to test it's performance.

 

[Kespaa]

Thank you, I fired up the 1st gpu after installing the g10 and it knocked my config out of Xfire.

I am still heavily under peforming in benchmarks however, can you suggest anything else to check?

 

[unknownofprob]

try all slots for both cards, you may have your second GPU running in X4 mode.