Display says "Not supported" when the computer isn't running in safe mode.

[Yoavgat1234]

I just recently bought an MSI Cubi to use as a media PC for my living room, but whenever I turn it on I can see it booting upand then my tv says its not supported. The Cubi works fine on the bedroom TV, and does run on the living room TV while in safe mode (which I can only enter if I unplug it while its booting, forcing it to open the troubleshoot menu the next time it boots up).
Any suggestions?

 

[Pigsteer]

what port and cable are you using?

 

[SkyNetRising]

Boot in safe mode and set resolution/refresh rate to values that your TV supports.
Check your TV user manual for supported resolution/refresh rate values.

 

[Yoavgat1234]

what port and cable are you using?

HDMI on both ends.

 

[Yoavgat1234]

Boot in safe mode and set resolution/refresh rate to values that your TV supports.
Check your TV user manual for supported resolution/refresh rate values.

I was gonna try that but unfortunately you can't do that in safe mode for whatever reason. I'll try doing it on the other TV and then bringing it back to the living room and tell you how it goes.

 

[Yoavgat1234]

Boot in safe mode and set resolution/refresh rate to values that your TV supports.
Check your TV user manual for supported resolution/refresh rate values.

The refresh rate was set to 59, so I tried setting it to 60 to see if it would make any difference but same results... Anything else I can try?

 

[SkyNetRising]

What are model names of those TV-s? Do they support same resolutions?