geofelt :
Unless you are an extreme overclocker, I think it is best to work first with the max multiplier alone and let all else default.
Just keep raising the multiplier until you are no longer stable.
OCCT is a good tester. It will tell you the vcore and other readings. It shuts down the test at 85c.
If you go no higher than 1.25 vcore, you should be good. 1.30 max.
Over that is not good for 24/7 operation.
other than the vrin (which I set to 1.8v) all I did was change vcore, which is set 1.102 but seems to show 1.116 in classic mode. Multiplier is up to 42.
I ran prime95 blend test for about 12 hours and max temp was 84 or 85. Now my idle temps are around 28-30.
Here are specs from occt when idle:
here are specs from occt after 2 min (thought might give a better idea of voltage specs)
not sure why it shows vin1 at 2.04, if i set VRIN to 1.8v in BIOS (is it the same? I thought I read somewhere that it is the same).
Anyways, does this stuff seem ok to you? Seems to be stable, my idle temps are low, and when gaming I get to 55-60c which seems fine. The only thing I really did that I am unsure with was set to VRIN to 1.8v but I read in a guide that it was a good starting point and that having it on auto could make it go higher than necessary (but if VIN1 in occt is the same thing, it seems to be going higher anyways...).
Thank you!!