Question Does anyone know how to set up the Reset Sw+/Power Sw+/H.D.D Led+/Power LED on the H110-I/G11CD/DP_MB ?

[aidsvm]

I’ve recently got this new case and decided to move my parts to the case, but I’ve ran into an issue with these pins and I have no idea how to set them up, there is literally no support for this motherboard at all.

https://imgur.com/a/YPpkGbU

https://imgur.com/a/waZKwf1

 

[Gam3r01]

There is a tiny diagram screenprinted just below the PANEL header.
See page 10 here: https://dlcdnets.asus.com/pub/ASUS/mb/LGA1151/H110I-PLUS/E11133_MB_Pin_Definition_v2_web_only.pdf

 

[aidsvm]

There is a tiny diagram screenprinted just below the PANEL header.
See page 10 here: https://dlcdnets.asus.com/pub/ASUS/mb/LGA1151/H110I-PLUS/E11133_MB_Pin_Definition_v2_web_only.pdf

Yessir, I did see that, but I am still quite confused as the diagram is not properly lined up, nor do I know if I put the pins in the JLED2/JLED1/ or the Panel section. (Sorry, I’m new to pc building.)

 

[Gam3r01]

The manual has the diagram (20-8 pin) properly lined up, you plug them into the PANEL section

 

[aidsvm]

The manual has the diagram (20-8 pin) properly lined up, you plug them into the PANEL section

For the Power Sw, it says power and ground, how would i plug the pin in for that?

 

[Gam3r01]

The + would be power, - would be ground (labeled on the actual wire in your first picture)
Generally, the letters should face out.

 

[aidsvm]

The + would be power, - would be ground (labeled on the actual wire in your first picture)
Generally, the letters should face out.

Thank you so much man! Helped me so much