Does the LED header on the Asrock Z270 Extreme4 act as an RGB header

[zevi230]

Hi, im about to buy this motherboard as an ugrade. Regarding my question, for example with the corsair 570x case that requires you to plug it in to an rgb header will it work as one?

 

[jojesa]

Hi, im about to buy this motherboard as an ugrade. Regarding my question, for example with the corsair 570x case that requires you to plug it in to an rgb header will it work as one?

The header is called "RGB LED Header", so it is for LED and RGB LED.
So it should work with any compatible 4-pin RGB LED lighting up to 12V/3A, 36W
RGB (red, green and blue) LEDs products combine these three main colors to produce over 16 million hues of light.

 

[Calvin7]

No, the Power LED and Speaker Header is not for that.

The AURA RGB LED Header* is for your RGB hardware.
*Supports up to 12V/3A, 36W LED Strip

 

[racksmith101]

Nope, a fan header is a fan header, RGB headers have a completely different pinouts and header type. The Asrock Z270 Extreme4 has a RGB header at the bottom edge of the motherboard.

 

[zevi230]

Hi, im about to buy this motherboard as an ugrade. Regarding my question, for example with the corsair 570x case that requires you to plug it in to an rgb header will it work as one?

The header is called "RGB LED Header", so it is for LED and RGB LED.
So it should work with any compatible 4-pin RGB LED lighting up to 12V/3A, 36W
RGB (red, green and blue) LEDs products combine these three main colors to produce over 16 million hues of light.

Idk about the voltage of the fans on the case, it would be nice if you found it

 

[zevi230]

Nope, a fan header is a fan header, RGB headers have a completely different pinouts and header type. The Asrock Z270 Extreme4 has a RGB header at the bottom edge of the motherboard.

So if the case requires an RGB header to control fan lighting, im fine?

 

[jojesa]

Idk about the voltage of the fans on the case, it would be nice if you found it

Don't worry about that, you will connect the fans to fan headers. Corsair fans draw around 0.30 - 0.40 Amps per fan, so you could have a lot more.

So if the case requires an RGB header to control fan lighting, im fine?

Yes, just make sure to plug it on the 4-pin RGB LED header. Check the manual in the motherboard box.

 

[racksmith101]

As long as it's a 12vGRB pinouts on the fan connector for the case you should be fine, but Check the pinouts in the fan controller documentation and make sure they are the same, not 12vRGB or your colours will be all messed up.

 

[devbiker]

DO NOT plug that case into the header on your motherboard. The Corsair RGB fans use 5V RGB, not 12V. You will burn out the fan RGBs.

In fact, you'd have to hack it to get it to actually connect to the motherboard header. General rule of thumb: if it doesn't go in easily, don't do it.