E6300 bottleneck

cua8er

Distinguished
Jan 4, 2010
18
0
18,510
hi, was just wondering, i have a pentium E6300, dual core Wolfdale @ 3.4Ghz overclocked from 2.8Ghz.....running on an asus p5q-pl mobo, 4gig mushkin 800Mhz DDr2, and an MSI 4870 1 gig. all this is usually run on my 42" plasma tv, but also runs on a 15" 1024x768 monitor......is my cpu bottle necking my gfx in any way? i have an asus p5k-premium board but been lazy to install in, would that make any difference (huge) in performance?

thanks alot
 
Solution
If your PSU is quality, 80+, it should be fine. I have an Antec 550 and an overclocked Q9550 as well as a similar overclock on a HD4870. Your Voltage is a little higher then mine (1.086) but I wouldn't think you have to worry unless you have 3-4 hard drives in the same machine.

cua8er

Distinguished
Jan 4, 2010
18
0
18,510
3.6 is all i get out of it with stock cooling and stock voltage.....any voltage reccomendations for it? right now according to cpu-z its voltage is at 1.120V....

and i only have a 500W cooler master lite ps, so is that enough for overclocking further?

my 4870 is also overclocked, running at 850 core and 1050 memory.....is my ps going to struggle if i overclock my cpu into the 4Ghz mark?
 

jfurterer

Distinguished
Nov 21, 2008
80
0
18,640
If your PSU is quality, 80+, it should be fine. I have an Antec 550 and an overclocked Q9550 as well as a similar overclock on a HD4870. Your Voltage is a little higher then mine (1.086) but I wouldn't think you have to worry unless you have 3-4 hard drives in the same machine.
 
Solution


Get an aftermarket cooler and increase the stock voltage. The "stock voltage range" is up to 1.36v...and it's generally considered safe if you keep it not too far above 1.4v

I have an E5300 @ 2.6GHz ---> 3.6GHz with 1.32v
Try increasing your voltage to 1.26 or 1.3 or so and set it to 4GHz




Your CPU is not a huge bottleneck. You have a minor bottleneck, but it can easily be solved with an overclock. (look at my Tomshardware link in the 2nd post to compare E6300 + 4890 bottlenecks). Overclock several hundred mhz and you should be good to go. Th E6300 can reach 4GHz and over without much difficulties.