Good Day,
This board requires extra power via a Molex connector. The wires are
Black, Yellow and Brown where Black is common and Yellow is +12 volts.
Brown is usually +3.3 volts. My question is...
Since typical Molex connectors have Yellow, Black, Black and Red, (+12,
common, common, +5 volts), does this card really need +3.3 volts? If not,
is it Ok to just ground this pin?
Thank you for reading,
Peter (aka: Wish2FixIt)
Vancouver, BC
This board requires extra power via a Molex connector. The wires are
Black, Yellow and Brown where Black is common and Yellow is +12 volts.
Brown is usually +3.3 volts. My question is...
Since typical Molex connectors have Yellow, Black, Black and Red, (+12,
common, common, +5 volts), does this card really need +3.3 volts? If not,
is it Ok to just ground this pin?
Thank you for reading,
Peter (aka: Wish2FixIt)
Vancouver, BC