Question Expo won’t post.

[Flawedhatred]

I recently upgraded to an AM5 setup, specs below:
Asus RIG strix X670e-F motherboard
Ryzen 9 7900x3d
4x G.skill trident z5 neo rgb series (amd expo) DDR5 16gb 6000mt (F5-6000J3038F16GX2-TZ5NR)
Evga ftw 3080ti
Super flower titanium 1000w

My ram will not run higher than 3600mhz, I’ve tried enabling expo1 and 2, neither will post I get an error when posting, and it takes north if 5 minutes for the system to fail to post. I’ve tried manually changing the speed incrementally and I can get the system to start up to 4800mhz, but it’s unstable and my system starts to blue screen. I’ve never had this issue when trying to push the memory up to the advertised speed but I can’t figure out what else I can adjust, I’ve updated all drivers, I’ve tried rolling back to different MB drivers that’s other people have had success with but still no luck getting the ram up to speed.

 

[Flawedhatred]

I should also add I’m aware that the 7900x3d is officially only going to run up to 5200, but I can’t even get the ram to run at 4800 stable let alone 52!

 

[Hotrod2go]

Be sure the mobo bios is up to date & not a beta version either. Running 4 DIMMs can be challenging with Zen 4.

 

[SkyNetRising]

I recently upgraded to an AM5 setup, specs below:
4x G.skill trident z5 neo rgb series (amd expo) DDR5 16gb 6000mt (F5-6000J3038F16GX2-TZ5NR)

My ram will not run higher than 3600mhz, I’ve tried enabling expo1 and 2, neither will post I get an error when posting, and it takes north if 5 minutes for the system to fail to post.

Try with only two modules. Use modules from same kit.
What DDR voltage are you using? It may need to be increased to 1.35V for stable operation.

Note - you have two kits - 2x16GB + 2x16GB.
Modules in same kit are tested for working together.
Modules in different kits are not tested for working together.

Why didn't you go with 2x32GB kit instead? That would have guarantied compatibility.