Newbie overclocker here looking for help.
OC'd cpu then ran a prime95 test (small FFT) after about 40 mins worker 6 encountered an error and stopped, there was no warning just an error.
Because of this error I tried increasing the voltage by the smallest incriment and tried to relaunch but windoows failed to boot. I was able to get into the bios still and restore defaults.
I'm new to this so no doubt I've done someting wrong, if anyone can help out that'd be great
Setup:
Z390 aorus elite
9600K
2x8GB 3200 corsair vengeance rgb (XMP enabled)
1060 3GB
600W 80+ bronze psu
OC'd cpu then ran a prime95 test (small FFT) after about 40 mins worker 6 encountered an error and stopped, there was no warning just an error.
Because of this error I tried increasing the voltage by the smallest incriment and tried to relaunch but windoows failed to boot. I was able to get into the bios still and restore defaults.
I'm new to this so no doubt I've done someting wrong, if anyone can help out that'd be great
Setup:
Z390 aorus elite
9600K
2x8GB 3200 corsair vengeance rgb (XMP enabled)
1060 3GB
600W 80+ bronze psu