Fan Configuration On Phanteks Enthoo Luxe

[nathanielnderson]

Hey there. I've got a quick question here for the community. I've got a phanteks luxe case with the fan hub on the back and I have a nzxt kraken x62. I current have the kraken plugged in to the cpu header on my Asus z97 pro. I can see it's 4pm just fine in my bios. I have the fans that are on the radiator also plugged in to its fan headers included on its cable. I've got my hub plugged in to cpu optional header and my case fans all plugged in to the hub on the back. I'm unable to see the 4pm reading on these but they are being powered no problem. I'm wondering if this is fairly standard to see no reading on them and also just to make sure my setup is proper and to figure out if the speed on these can be mortified. Thank you in advance.

 

[Aeacus]

Depending on your fan hub (in CPU_OPT header), you may or may not see the RPM of 1st connected fan. But you definitely can't see RPMs of all fans that are connected to the fan hub.

Again, controlling fans plugged in to the fan hub depends on the fan hub itself. Some fan hubs can control only 3-pin fans while others can control only 4-pin fans. But in general, controlling the hub is done via BIOS where you control that specific header (CPU_OPT for you).