My case is an Antec NX800, which has 2 pre-installed 200mm fans on front, spot for 1 rear and 2 top.
Mine is set up with 2 x 200mm at front, 2 x 120mm at top and 1 x 120mm at rear, have been using it fine temperature of components not too bad. But not sure if I have them set up for good airflow/cooling. How should I have them set up ? as of right now I believe it sucks air in back and blows out front and top
Mine is set up with 2 x 200mm at front, 2 x 120mm at top and 1 x 120mm at rear, have been using it fine temperature of components not too bad. But not sure if I have them set up for good airflow/cooling. How should I have them set up ? as of right now I believe it sucks air in back and blows out front and top