Final Look at my First Build

[jabroni]

Alright, so I have finally gotten everything I am going to buy for my first build together. I just want to have one last look over it to make sure everything I am going to do will work for me, and that I have every part/cable I need to make this system run. I do 2D and 3D computer animation/programming, and my girlfriend does CAD. I will also be gaming a little.

Here is a list of everything I am getting. Budget is right around 2500-2600 give or take.

Newegg List

Twin Frozr III PE GTX 570 from Amazon

2x 23" Ultrasharp monitor from Dell

Surge Protector from Dell

Lamptron Touch from FrozenCPU

Dust Filters from FrozenCPU

Alright now that everything is listed here is what I am going to do. I am going to replace the rear fan in my case with the 135mm Scythe Fan.

Then I am going to add the 200mm Megaflow Fan to the top of the case, and switch both top fans from exhaust to intake giving the case great positive pressure. I am going to connect both of these fans to 1 channel of the fan controller using the 3 Pin Splitter.

I am going to add the Blademaster Fan to the Hyper 212+ in a push/pull setup and connect both fans to 1 channel of the fan controller using the Gelid PWM splitter.

The 120mm CM fan will be going in the VGA dock of the case.

Is there anything else that I need? Will everything work properly with the parts i have mentioned?

 

[geekapproved]

Your list does not work.

 

[jadedmonkey]

2 x 23" monitors and using CAD? go 6950 2GB or 6970 2GB and save some $ off the GTX 570. I tend to need more GPU memory than CUDA

 

[jabroni]

alright i fixed all the lists now, I was thinking about getting more GB on my GPU but I dont know except for the GTX 580s. I dont know about AMD cards.