I have Alphacool 16mm OD 13mm ID acrylic tubing, and a Alphacool 13mm silicon insert.
When I am bending tubes there is about a 1mm to 2mm gap between the insert and tubing, and it is messing up all of my bends. Is there a way to fill in the unfilled gap of air? Or did I just get a messed up insert?
When I am bending tubes there is about a 1mm to 2mm gap between the insert and tubing, and it is messing up all of my bends. Is there a way to fill in the unfilled gap of air? Or did I just get a messed up insert?