GA-Z170-Gaming K3 EU rev. 1.0 defect

MachineDeth

Commendable
Jun 29, 2016
24
0
1,510
So i just put in that used gigabyte board in my pc n after tryin to start the pc fully loaded with the components number gradually decreasing with only the cpu psu, board psu n the board speaker and pw switch still in it still gives that error message. It beeps a total of 5 times before rebooting abd starting over, but before it starts beeping it firstly doesnt do anything for five seconds or so. Every beep tone seems to take 2 sec.
Could u help me out with this?
 


what error message?
and what is your full system spec?
 
It was the ram the fuckin ram man
Cant believe this wtf im really no one who does such mistakes





No error msg unfortunately, theres bo video signal... Not with my gpu neither withe obboards vga.
Those components are all cometely new and tested and working on my just recently used gigabyte ga-b150-hd3p:
i5 6600k
8 gigs ram one stick with 2133mhz
Be quiet psu 530w
Gigabyte gtx 560 ti 1 gig
Some hdds and a ssd
Arctic freezer 7 pro rev 2, if that could be of any use
Only usb mousen keyboard, but thats not the issue right now

Edit: didnt see your msg. I akready tried to clear the cmos via jump n also by unpkugin the battery.
And just now i tested same minimum setup on my other mb and i could go into bios no beeeeeeps! But one thing is very strange, that my cpu went very fuckin hot! 100°c thats the max of any chip in a pc or thats the temp when water begins to boil. First i didnt trust the value but then i unlocked tge cpu and it was really melting. Now it could be that this is because ive no fan on it obviously right now, was usin onboards vga and already applied thermal paste but the reason why im concerned tgen is, is because may be because tge cpu is too hot? Ive just switched to thermal grizzlys kryonaut and that with the arctic freezer cooler mentioned above. Is this alright? Ive used the arctic freezer thermal paste that came with the fan just for this board i switched.