I am tired of asking over and over again for help and getting nowhere, so this is my last time.
I have
Asus 970 pro gaming/aura
Amd 6350
8 GB ddr3 Hyper X savage x 2
Hyper evo 212 cooler
1500W psu
Raedon r290x GPU
I have read the overclock tutorial, read everything I can find, watched videos for the board, and the cpu. And still I am getting just no where.
The issue lies with my thermal margin and my cpu voltage.
So first, I ran prime 95 on small fft’s for 15 minutes with everything set to optimized defaults in the BIOS to get a baseline. Coretemp shows VID at 1.3875 while hwinfo shows cpuVID at 1.388.
BIOS shows CPU manual voltage at 1.38, the monitor tab on my BIOS shows 1.38. When I set the cpu manual voltage to 1.38, I reach my thermal margin in 2.5 minutes flat. The tutorial says don’t go any closer than 10C before tjmax, I stopped at 15C before.
With everything set at optimized defaults I go no higher than 34c before tjMax.
So what am I doing wrong then?
If no one will help me make sense of this I will try a different forum, or just by a Dell and call it good.
I have been trying to overclock this thing for years and now with everything shut down, I have time to get good and mad at my lack of production here.
Can someone with real experience and a little time please help?
I have
Asus 970 pro gaming/aura
Amd 6350
8 GB ddr3 Hyper X savage x 2
Hyper evo 212 cooler
1500W psu
Raedon r290x GPU
I have read the overclock tutorial, read everything I can find, watched videos for the board, and the cpu. And still I am getting just no where.
The issue lies with my thermal margin and my cpu voltage.
So first, I ran prime 95 on small fft’s for 15 minutes with everything set to optimized defaults in the BIOS to get a baseline. Coretemp shows VID at 1.3875 while hwinfo shows cpuVID at 1.388.
BIOS shows CPU manual voltage at 1.38, the monitor tab on my BIOS shows 1.38. When I set the cpu manual voltage to 1.38, I reach my thermal margin in 2.5 minutes flat. The tutorial says don’t go any closer than 10C before tjmax, I stopped at 15C before.
With everything set at optimized defaults I go no higher than 34c before tjMax.
So what am I doing wrong then?
If no one will help me make sense of this I will try a different forum, or just by a Dell and call it good.
I have been trying to overclock this thing for years and now with everything shut down, I have time to get good and mad at my lack of production here.
Can someone with real experience and a little time please help?