GTX 770 and only 1 8pin power connector

Ash_BMW

Reputable
Mar 17, 2014
26
0
4,530
Seems the bundled cooler master psu only has 1 1x8 connector and my card requires 2 x 8 pin.

I have 3 molex connectors can i use these with an adaptor as well as my 1x8 to power my MSI GTX 770? or can you use a 1x6 pin to 2x8 adaptor?

Gutted really as the cooler master website has a picture which states 2 x 8 pin PCie


Il be upgrading psu when i over clock but need something to get by with now :)
 
Solution


You only have 396W available on the 12V rail. The stock GTX 770 requires around 190W (16A) max on the 12V rail. The PSU has 2 12V rails with 19.5A available on each and 1 with 19A (but watch the wattage max!).

Theoretically, you can run the 770 on just about any system with an available 396W and that much amperage on the 12V rail. Will a 770 work with this power supply, yes. Would I personally plug a GTX 770 into that power supply? No. It was designed for systems built around 10 years ago. This is evidenced by the available wattage on the 3.3V and 5V rails...
Cooler master RS 500 500w. Im close to the line on power for my setup, but as i say i will be upgrading PSU when i overclock. It can in a bundle so cant complain.
 
Second that, what is your model of your PSU?

You can use 2+6 connectors for the 8 pin requirement. But if your PSU only came with one 8 pin connector (including 2+6 and 8 pin), then that' leads me to believe that your PSU might not be capable for running that card.

Edit: Just saw your post. A good 550W would even be pushing it (if even slightly) for a GTX 770. Using a lower tier CM PSU @ 500W is asking for problems.
 


You only have 396W available on the 12V rail. The stock GTX 770 requires around 190W (16A) max on the 12V rail. The PSU has 2 12V rails with 19.5A available on each and 1 with 19A (but watch the wattage max!).

Theoretically, you can run the 770 on just about any system with an available 396W and that much amperage on the 12V rail. Will a 770 work with this power supply, yes. Would I personally plug a GTX 770 into that power supply? No. It was designed for systems built around 10 years ago. This is evidenced by the available wattage on the 3.3V and 5V rails.

Onus has alluded to the fact and provided evidence the PSU is junk. You should heed this warning or you may end up ruining your PC altogether.

You need to upgrade your power supply if you value your components. You don't want to mess up a $350 video card because you ran it on a flawed $30 power supply.
 
Solution
You're going to get top-quality out of the Seasonic I recommended, though the Corsair CX600 will also be sufficient. That Corsair supply is built by Channel Well which is the CPU manufacturer that put Corsair on the map as a player in the power supply space with the TX series. I wouldn't hesitate to buy a PSU built by Channel Well as I had a TX950 that was one of Corsair's highest-rated and best-quality PSUs out there built by Channel Well.
 
Some of the earlier "CX" were built by Seasonic, but all the newer ones (the last 2-3 revisions) are from CWT. CWT is hit or miss. I would not say "junk" by any stretch, but cost-cutting does not lead to quality. Kept cool, a CX-600 would be "acceptable;" anticipate getting 2-3 years out of it rather than the 5+ you might get from a Seasonic
(I'm going on six or seven years with my Delta-built SG-650).
 
It entirely depends on the overclock. It's not an exact science. You have some headroom to work with using the 550W. If you want to overclock higher than a few hundred MHz and also want to OC the GPU, you may need more. I'd recommend the XFX 650W in that case. If the CX600 is in your price range, it will give you some extra to work with, but you'll get the higher-quality build from XFX.