Help wiring LED wires into F panel on motherboard.

Justin21

Commendable
Jul 14, 2016
101
0
1,680
I am a bit confused, I got the Power and Reset, but the others don't quite match up.

I need to wire in "H.D.D LED" which is two slots connected together
I also need to wire in "Power Led" which is two slots but are separate. (One -, one +)

This makes sense to me however the F panel has the following pin spots:
+PLED-
+HD-
+PW-
-RES+
-CI+
+Speak-
+Pwr_Led-

I believe that the HDD LED goes into PLED
and Power Led goes into Pwr Led is this correct?

And if so, there are 3 pins for the pwr led, but only two slots on the wire, do I do left and right and skip the middle?

I appreciate any help
 
Solution
PLED is the power LED.
HD is the hard drive LED.
PW is the power switch.
RES is the reset switch.
CI is chassis intrusion switch.
Speak is the speaker header.
Pwr_LED is another power LED.

The reason for two power LED's is that some cases have a multi-color light that needs a second connector.

Try the power LED wire in PLED, and if that doesn't yield a favorable behavior then put it in Pwr_LED.

Not all cases have a chassis intrusion switch. It's okay to leave that empty if your case doesn't have that feature.
PLED is the power LED.
HD is the hard drive LED.
PW is the power switch.
RES is the reset switch.
CI is chassis intrusion switch.
Speak is the speaker header.
Pwr_LED is another power LED.

The reason for two power LED's is that some cases have a multi-color light that needs a second connector.

Try the power LED wire in PLED, and if that doesn't yield a favorable behavior then put it in Pwr_LED.

Not all cases have a chassis intrusion switch. It's okay to leave that empty if your case doesn't have that feature.
 
Solution


Oh okay, that makes sense, is it normal for it to not have a speaker header?