Help with fans to Phanteks Enthoo Pro

[r0qver]

Hello,

So I need your help with the fan setup on my case.

I recently got a phanteks Enthoo Pro, it comes with a 200mm on front (PH-F200SP) and a 120mm(PH-F140SP) on the back.

I removed the 120mm one because I have a Corsair hydro 80i gt, and i've put the radiator on the back, with fan on exhaust.

From my previously build i have 4 Noctua NF-A14 PWN, so my question is, should I remove the front 200mm fan and put it on top, and 2 Noctua on the front? And should i connect them all the pwn hub?

Thanks in advance, and sorry for bad english (not main language).

 

[gareththegiant]

Personally I would do as you suggested either way that is a lot of air flow.

 

[r0qver]

Personally I would do as you suggested either way that is a lot of air flow.

Is it? It's only two noctua at the front as intake, the 200mm phantek fan and the corsair fan at the back as exhaust

 

[gareththegiant]

Well i suppose would depend on what fans are inside e.g. cpu fan. but yh your layout would have a fair amount of airflow which is primary for air cooling

 

[bote110]

I have the same great case Phanteks Enthoo Pro.
The case comes with a 200mm in the front an a 140mm in the back.
Fan Compatibility page 13 on the manual
Top-3x120mm,3x140mm,or 1x200 fan's
Front-2x120mm,2x140mm,1x200mm fan's
Bottom-2x120mm,or 1x140mm fan's
Rear-1x120mm, or1x140mm
I don't think all will connect to the the pwn hub because of the distance some will have to use the mother board fan headers. {could be wrong}

 

[gareththegiant]

you can get pwm extenders for example,

http://www.amazon.com/extension-cable-Black-Sleeving-FC44PWM-12BKS/dp/B0055OLY88