So, due to Zotac's lack of proper product warranty (based on age from serial nr etc) I'm now on my own in trying to get my belowed 3060 Ti to work agian.
Card was bought in June 2021, but with a pre-built PC, which I again bought 2nd hand in August. The PC I (unlucky for me) sold on after taking out the card. If I had it I could of course get it on warranty by handing the whole PC in where I bought it, but that ain't possible, so here I am...
I've taken apart the card now and started measuring with the multimeter on the different "power stages", however I'm still very confused about what is what,
I'm attacing a couple of pics. Is it correct that the 1 and 2 (orange circles) are power controllers, and if so, for what?
I've only been able to measure 12v and 3.3v here and there around the board, the 5volt doesn't seem to be present at all.
Also, what I believe to be the resistance between earth and the core I measure to 1.2-1.3 Ohm. I hope this means that the core is likely not dead?
Would appreciate if anyone can give me any clues how to get on with this.
It also struck me why there is no voltage on the two silver/pink coils on the left row, are these probably 5v coils, the other silver/black ones measure 12v on the right side as illustrated.
Thanks in advance for any relevant input, or a redirection to a different forum where there might be a bigger chance of getting any answers.
Regards
Kristian
Card was bought in June 2021, but with a pre-built PC, which I again bought 2nd hand in August. The PC I (unlucky for me) sold on after taking out the card. If I had it I could of course get it on warranty by handing the whole PC in where I bought it, but that ain't possible, so here I am...
I've taken apart the card now and started measuring with the multimeter on the different "power stages", however I'm still very confused about what is what,
I'm attacing a couple of pics. Is it correct that the 1 and 2 (orange circles) are power controllers, and if so, for what?
I've only been able to measure 12v and 3.3v here and there around the board, the 5volt doesn't seem to be present at all.
Also, what I believe to be the resistance between earth and the core I measure to 1.2-1.3 Ohm. I hope this means that the core is likely not dead?
Would appreciate if anyone can give me any clues how to get on with this.
It also struck me why there is no voltage on the two silver/pink coils on the left row, are these probably 5v coils, the other silver/black ones measure 12v on the right side as illustrated.
Thanks in advance for any relevant input, or a redirection to a different forum where there might be a bigger chance of getting any answers.
Regards
Kristian
Last edited: