So I'm setting up a home network. The basic setup is Router - PoE Injector - ethernet cable up to a wall socket, and then ethernet cable wired from the socket into network switch, delivering data and PoE power over the single cable.
However, I cannot seem to get the wall socket cables to work. I've tried rewiring the cable at both ends, using different cables, using different wall sockets, and I'm met with failure every single time. They deliver power but not data. I'm using a Ubiquiti USW Flex Mini. It has lights to show both power and data status. The power light comes on when I plug in but the data light doesn't with these cables. I've isolated the problem to this part of the chain in particular. The network is running to 4 places and it's happening in every single one of them. The cables being used are from a large spool and all the other cables from the spool work flawlessly.
I'm at my wit's end as I don't know what to change or test any more. I think I've covered all bases.
However, I cannot seem to get the wall socket cables to work. I've tried rewiring the cable at both ends, using different cables, using different wall sockets, and I'm met with failure every single time. They deliver power but not data. I'm using a Ubiquiti USW Flex Mini. It has lights to show both power and data status. The power light comes on when I plug in but the data light doesn't with these cables. I've isolated the problem to this part of the chain in particular. The network is running to 4 places and it's happening in every single one of them. The cables being used are from a large spool and all the other cables from the spool work flawlessly.
I'm at my wit's end as I don't know what to change or test any more. I think I've covered all bases.
Last edited: